Accessories

To obtain good measurement data, the strain gage must be completely bonded to the material to be measured. It is important to select and use an adhesive suitable for the material to be measured, the material of the gage base, and the measurement conditions.

Coating agents are applied to gages and gage terminals to prevent gages from adsorbing moisture in outdoor or long-term measurements.

· Prints an index number and a channel number in 4 digits each. · Enables selection of Lister print or Texter print. · Provides approx. 250 kinds of units by input of 8-bit codes. · Power supply: 100 to 240 VAC · Provides calendar clock.

Sensor input adapter for the MRS-100 Series transmitter.

Power adapter for the MRS-100 Series transmitter.

This is a connector with a waterproof cap that protects the tip of the extension cable of the civil engineering sensor.

Auxiliary jig for installing a concrete surface displacement transducer (BCD-E-70S)

This is a mounting bracket or protective cover used to install a stationary inclination transducer on the wall or other flat surface with anchor bolts.

If the condition of the mounting surface (roughness, swells) is poor, the multi-force sensor may not be able to perform at its best. This is a dedicated base plate designed to maximize the sensor performance.

This filter prevents clogging of the pore pressure transducer when the pore pressure transducer is buried in clay soil or mud.

It has the same external dimensions as a strain gage and is used to secure the mounting leg for the strain gage.

This is a cylindrical special case used for non-stress gages. The strain gage is stress-insulated from the mass concrete. It measures the coefficient of linear expansion of the concrete and can obtain the correction value during analysis.

This is used when measuring compression load with a load cell. Attached to the side to be measured, it is used to reliably transmit the measured load to the load cell.

The CAC1R0 is Charge converter for Charge Output Piezoelectric Acceleration Transducer.

This is used to protect the load receiver of the load cell. Use this when impact loads are frequently applied to the load receiver of the load cell.

This is the termination resistor for CAN bus lines.

These are jigs for planar or 3D stress measurement that can maintain the angles between the strain gages.

This is used when the installation surface on which the load cell is installed cannot withstand the load, or when the load cell cannot be secured from below.

This is used to attach the load cell when measuring compression load with a load cell.

This is the dedicated socket for buried installation of seam gages.